Joint It Filler for Paving is a ready to use paving joint compound that can be applied in dry or wet weather.
It is frost, weed and power washer resistant and ideal for jointing paving slabs, cobbles, porcelain and natural stone.
Simply open the tub and brush in, no need for mixing or stir ins.
Key features:
- Ideal for jointing paving slabs, cobbles, porcelain and natural stone
- Ready to use paving joint compound
- Can be applied in all weathers
- You can walk on it within a day
- Frost, weed and power hose resistant
- Doesn't stain and is non hazardous
- 20kg bucket
- Long lasting
- Eco friendly
Joint it filler for paving is used extensively by paving professionals and also in DIY projects throughout Ireland and saves you time and effort.
Traditional sand and cement methods of pointing are extremely time consuming and laborious.
This simple to use, sweep-in jointing grout means gets the job finished faster and stands the test of time.
Where other grouts and mortars can crack and loosen, allowing weeds to grow, Joint-It sets rock hard.
It is specially formulated with 7 unique, specialist glues to ensure that it will stay in your joints for many years to come.
Instructions:
- You must soak your finished paving with water before you open your bucket of Joint-It Simple.
- Keep the paving soaked with water while you work.
Do not allow the paving to dry as you work with the product.
Keep re-wetting the paving as you work.
- The product is vacuum packed tightly inside the bag.
Open the bag and tip the product out onto your wet paving.
- Use a hard bristle brush to work the product into the joints.
You must soak your paving with water before you start to sweep Joint-It Simple into the joints.
- Keep the paving soaked with water while you work.
Do not allow the paving to dry as you work.
Keep re-wetting the paving as you work with the product.
- When all of the joints are full of product, and the paving looks like this, then soak the paving again with water.
- Allow the paving and product to dry.
Depending on weather conditions, this will take between 15 and 45 minutes approximately.
- Using a soft bristle brush, sweep over the paved area and top up joints with product until all of the joints are completely full.Sweep up and remove any excess product.
- You can see the Safety Data Sheet here
Hints and tips:
- Joint-It Simple must be used on a permeable base.
This is to allow water to drain through instead of logging on the top of your slabs.
We recommend a 6:1 sand and cement base.
- Joint-It Simple is not suitable for V joints.
- Joints must be a minimum of 3mm wide and 25mm deep to ensure the product is secure.
- We strongly recommend Limestone and Flamed/Honed Black Granite are pre-sealed prior to application of Joint-It Simple.
- While this product is low maintenance, all patios require some level of maintenance annually, particularly in shaded areas or after the winter.
A quick application of Joint-It So Clean keeps your patio looking new and refreshed.
