Minimum Order Quantity: 5 items
Thin-R Partial Fill Cavity Wall XT/CW (T&G) builds to a system thanks to its engineered tongue and groove joints and pre-formed corners, ensuring insulation continuity and minimisation of thermal bridging.
XT/CW (T&G) for use in traditional masonry walls, builds to the highest thermal standards whilst maintaining a residual cavity, offering protection from wind driven rain.
- Thermal conductivity is 0.022 W/m²·k (BS EN 13165:2008)
- Thermal Resistance for this 80mm T&G is 3.60 W/m²·k
Unilin (previously Xtratherm) Cavity Tongue and Groove 80mm features:
- Robust Tongue & Groove Jointing
- Corner Panels & Cavity Closers: Reduced Thermal Bridging
- Clear Cavity Maintained
- 1200mm x 450mm x 80mm
- No Exposure Restrictions
- Low Emissivity Foil Facings
- Reaction to fire: NPD
- Compressive Strength > 120 (kPa)
- See the Product Brochure and Installation Instructions here
- See the Declaration of Performance here
- If you require very large quantities then you can call us on 0818 888 000 and we can provide a separate quotation for very large quantities.
The Unilin (previously Xtratherm) Cavity Wall System includes an optional pre-formed corner panel (XT/CRN) that folds to 90 degrees to effectively insulate a corner junction that is normally vulnerable to thermal bridging and cold spots.
The XT/CW (T&G) tongue and groove jointing offer a practical on-site solution that results in a more robust continuous layer of insulation, minimising the threat of thermal bridging and improving the overall U-Value of the wall.
The low emissivity foil facing on XT/CW (T&G) improves the thermal performance of the wall.
The residual cavity is the most effective method of preventing wind-driven rain from penetrating a wall from the outside.
A residual cavity is the air space that remains when XT/CW (T&G) is placed against the inner leaf of the cavity of a wall.
The recommended residual cavity width required is 50mm in accordance with agrément certification, however, a reduced cavity may be permissible in certain circumstances.
Handling, Cutting and Storage
Xtratherm insulation should be stored off the ground, on a clean flat surface and must be stored undercover.
Polythene wrapping is not considered adequate protection for outside exposure.
Care should be taken to protect the insulation in storage and during the build process.
The insulation boards can be readily cut using a sharp knife or fine toothed saw.
Ensure tight fitting of the insulation boards to achieve continuity of insulation.
Appropriate PPE should be worn when handling insulation.
Please refer to Health & Safety data sheets on the manufacturer website.
The boards are wrapped in polythene packs and each pack is labelled with details of grade/type, size and number of pieces per pack.
Durability
Unilin (previously Xtratherm) products are stable, rot proof and will remain effective for the life span of the building, dependent on specification and installation.
Care should be taken to avoid contact with acids, petrol, alkalis and mineral oil.
When contact is made, clean materials in a safe manner before installation.
If you need any help with this Unilin (previously Xtratherm) Cavity T&G insulation then just call our helpful and friendly team today on 0818 888 000 or open up the live chat and we will help in every way we can.
Note:
Delivery of this bulky product is available Nationwide but will be subject to a bulk delivery charge.
Delivery charges are calculated during checkout according to the delivery address provided.
Should you require very large volumes of this product then we may be able to improve your delivery charge.
To discuss this you can call us on 0818 888 000 for more information and confirm pricing.
