Soudal Chemical Anchor 1400kg 280ml

CA1400 Chemical Anchor from Soudal

Key features:
  • High quality anchoring resin for the tension-free securing of anchoring rods, studs, reinforcing bars, threaded collars, profiles etc
  • Very strong anchoring – suitable for loads up to 1400kg
  • Fast-setting – can be exposed to loads after 30 minutes
  • Can be applied with a standard caulking gun
  • Can be used even in wet or damp conditions
  • Cartridge reusable by changing mixing nozzle
€15.99
Delivery in
2-3 days
SKU
117257
Brand
Soudal

Soudal Chemical Anchor CA1400 is a high quality anchoring resin used extensively in the UK and Ireland.

It secures the likes of studs, anchoring rods, rebar, threaded collars and profiles and provides tension free anchoring.

This is a 280ml cartridge and grey in colour.

Soudal Chemical Anchor is suitable for loads up to 1400kg and is fast setting - so much so that it can be exposed to loads after just 30 minutes.

You can apply this with a standard caulking gun and apply it in wet or dry conditions so it is ideal for the Irish climate in particular.

You can even reuse the cartridge by changing the mixing nozzle for your next project.

Key features:

  • High quality anchoring resin for the tension-free securing of anchoring rods, studs, reinforcing bars, threaded collars, profiles etc
  • Very strong anchoring – suitable for loads up to 1400kg
  • Fast-setting – can be exposed to loads after 30 minutes
  • Can be applied with a standard caulking gun
  • Can be used even in wet or damp conditions
  • Cartridge reusable by changing mixing nozzle
  • 280ml and grey in colour
  • Withstands temperatures up to 80°C
  • Easy to use and apply
  • Fast cure and styrene-free (low odour)
  • Can be used even in wet drill holes
  • Watertight and impermeable fixing
  • Indoor Emission LEvel (VOC) A+ (Very Low Risk)
  • Especially suited for installing, even close to edges, of hedges, banisters, shutters, fences, etc
  • Also suitable as a repair mortar for damaged concrete parts

Application instructions:

Thread mixing nozzle into cartridge.

Can be applied with a normal high performance cartridge gun.

Application temperature 5°C and higher.

Discard the first 5cm of extruded product, the colour must be homogenuously grey which indicates correct mixing of the components.

Remove nozzle and reseal after use.

Installation depends on the structure, may require sleeves.

Downloads:

You Might Also Like!